SYNOPSIS

PARAMETERS

INPUT PARAMETERS

• Lp : Parallel inductance (Farads)
• Rp : Parallel resistance (Ohms)
• Qp : Parallel quality factor
• freq : Analysis frequency (Hertz)
• flag : indicates if Qs or Rs should be used for the loss input
  • flag=0 : Qs will be calculated from Rs.
  • flag=1 : Rs will be calculated from Qs.
• Ls : Series inductance (Farads)
• Rs : Series resistance (Ohms)
• Qs : Series quality factor
• Lp : Parallel inductance (Farads)
• Rp : Parallel resistance (Ohms)
• Qp : Parallel quality factor

OUTPUT VALUES

DESCRIPTION

Function to calculate an equivalent series RL network from an input parallel RL network.

EXAMPLE

 % 10 nH
Lp=10e-9;
 % 5 kOhms
Rp=5e3;
 % This value will be replaced
Qp=100;
 % 100 MHz operation
f=100e6;
 % Use Rp (and calculate Qp)
flag=0;
[Ls, Rs, Qs, Lp, Rp, Qp] = parallel_rl_p2s(Lp, Rp,
  Qp, f, flag);
disp(sprintf('Equivalent series L = %g nH', Ls/1e-9));
disp(sprintf('Equivalent series R = %g Ohm', Rs));
disp(sprintf('Quality factor      =%g',Qs));

SEE ALSO

air_coil_calc
air_coil_syn
coax_calc
bars_calc
coax_syn
coplanar_calc
coplanar_syn
coupled_microstrip_calc
coupled_microstrip_syn
coupled_stripline_calc
coupled_stripline_syn
ic_microstrip_calc
ic_microstrip_syn
microstrip_calc
microstrip_syn
parallel_rc_p2s
parallel_rc_s2p
parallel_rl_p2s
parallel_rl_s2p
stripline_calc
stripline_syn

AUTHOR

Dan McMahill

BUGS

None known

Please report any bugs on the Wcalc Sourceforge Project Page

Return to the MEX-Wcalc page.